diff --git a/printer_data/config/printer.cfg b/printer_data/config/printer.cfg
index 9a08502..da5d06b 100644
--- a/printer_data/config/printer.cfg
+++ b/printer_data/config/printer.cfg
@@ -385,36 +385,6 @@ aliases:
     EXP2_7=PE8, EXP2_8=<RST>,
     EXP2_9=<GND>, EXP2_10=<NC>
 
-
-
-#####################################################################
-# 	Macros
-#####################################################################
-[gcode_macro PRINT_END]
-#   Use PRINT_END for the slicer ending script - please customise for your slicer of choice
-gcode:
-    SAVE_GCODE_STATE NAME=STATE_PRINT_END
-
-    M400                           ; wait for buffer to clear
-    G92 E0                         ; zero the extruder
-    G1 E-10.0 F3600                ; retract filament
-
-    G91                            ; relative positioning
-    G0 Z1.00 X20.0 Y20.0 F20000    ; move nozzle to remove stringing
-    TURN_OFF_HEATERS
-    M107                           ; turn off fan
-    G1 Z2 F3000                    ; move nozzle up 2mm
-    G90                            ; absolute positioning
-    G0  X125 Y250 F3600            ; park nozzle at rear
-    BED_MESH_CLEAR
-    
-    # The purpose of the SAVE_GCODE_STATE/RESTORE_GCODE_STATE
-    # command pair is to restore the printer's coordinate system
-    # and speed settings since the commands above change them.
-    # However, to prevent any accidental, unintentional toolhead
-    # moves when restoring the state, explicitly set MOVE=0.
-    RESTORE_GCODE_STATE NAME=STATE_PRINT_END MOVE=0
-
 #*# <---------------------- SAVE_CONFIG ---------------------->
 #*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
 #*#