printer.cfg modified - 07/06/2025 - 01:09:19 PM

printer_data/config/printer.cfg

@@ -1,5 +1,8 @@
 [include mainsail.cfg]
+
 [include macros/print_start.cfg]
+[include macros/stealtburner_leds.cfg]
+[include macros/status.cfg]
 
 [virtual_sdcard]
 path: /home/macocha/printer_data/gcodes
@@ -196,7 +199,7 @@ spi_software_miso_pin: EBBCan:gpio3
 axes_map: z,-y,x
 
 [resonance_tester]
-probe_points: 100, 100, 20
+probe_points: 175, 175, 20
 accel_chip: adxl345
 
 [neopixel sb_leds]
@@ -282,16 +285,6 @@ stealthchop_threshold: 0
 #####################################################################
 # 	Fan Control
 #####################################################################
-
-# [fan]
-# ##	Print Cooling Fan - CNC_FAN0
-# pin: PF7
-# kick_start_time: 0.5
-# ##	Depending on your fan, you may need to increase this value
-# ##	if your fan will not start. Can change cycle_time (increase)
-# ##	if your fan is not able to slow down effectively
-# off_below: 0.10
-
 [fan]
 pin: EBBCan:gpio13
 
@@ -357,6 +350,17 @@ retries: 5
 retry_tolerance: 0.0075
 max_adjust: 10
 
+[bed_mesh]
+speed: 300
+horizontal_move_z: 10
+mesh_min: 40, 40
+mesh_max: 310,310
+fade_start: 0.6
+fade_end: 10.0
+probe_count: 5,5
+algorithm: bicubic
+
+
 [board_pins]
 aliases:
     # EXP1 header
@@ -373,15 +377,6 @@ aliases:
     EXP2_7=PE8, EXP2_8=<RST>,
     EXP2_9=<GND>, EXP2_10=<NC>
 
-[bed_mesh]
-speed: 300
-horizontal_move_z: 10
-mesh_min: 40, 40
-mesh_max: 310,310
-fade_start: 0.6
-fade_end: 10.0
-probe_count: 5,5
-algorithm: bicubic
 
 
 #####################################################################